TOOLS REQUIRED
Before installing the Wall Connector, ensure
you have the following tools:
•
Pencil or marker
•
Drill and 9/32"and 3/16" drill bits
•
T20 torx driver
•
Hole saw (1 1/4" / 32 mm)
•
Sharp knife or razor
•
Phillips screwdriver
•
Ratchet wrench with 8 mm and 17 mm
sockets, and a 2" (minimum) extension
•
Voltmeter or digital multimeter (to
measure AC power at the site)
OVERVIEW OF STEPS
After running service wiring to the desired
installation location using 1" (25 mm) conduit,
(see pages 5 through 7), and installing the
appropriate circuit breaker (see page 8),
TURN OFF THE POWER SUPPLY. Then follow
these steps to install the Wall Connector:
1
Check box contents (see page 10)
2
Install wall bracket (see page 11)
3
Prepare for installation (see page 12)
4
Mount on wall (see page 13)
5
Connect wiring (see page 14)
6
Confirm a successful installation (see
page 15)
7
Set operating current (see page 16)
8
Secure cover and power up (see page 17)
9
Install Cable Organizer (see page 18)
NORTH AMERICA
Installation Overview
9