Sony SAL24105 Service Manual page 85

4) When the wide position check finishes normally, the message "Move ZOOM to TELE position. Then push [ENTER]." is displayed
on the pop-up window.
Set the zoom to the tele position and press down the ENTER key.
5) When the tele position check finishes normally, "OK" is displayed on the pop-up window, and press the ENTER key to return to the
initial window.
3. In case of error display in the Zoom Adjustment Point
1) When the error display and the NG display appear to the pop up window, press the ENTER key to return to the initial window, and
perform "2. Checking Method"again.
• In case of error at the wide position in the Zoom Adjustment Point
• In case of error at the tele position in the Zoom Adjustment Point
2) Although the lens is positioned at the tele position or the infinity position, if "NG" appears, confirm or perform the following.
• 4-9-1. Zoom Brush Position Adjustment (Search Zoom Adjustment Point)
• Cleaning of flexible pattern or the brush.
• Replaceing the brush.
3) Perform "2. Checking Method"again, repeat the inspection until "OK" appears on the pop-up window.
SAL24105 (3.5-4.5/24-105) (24-105mm F3.5-4.5)
Fig.4-9-12
Fig.4-9-13
Fig.4-9-14
Fig.4-9-15
Fig.4-9-16
Fig.4-9-17
4-34