Configuring The System - ADC HiGain H2TU-C-231 Manual

LTPH-TP-1034-01, Issue 1

Configuring the System

The Config menu (Figure
•
Standard options
•
ADC options (Figure 8 on page
•
Date and time (see
•
Master clear (see
•
Reset to factory default configuration, described in
Monitor Performance
ID: xxxx--xxxx—-xxxx--xxxx
Making Changes to Standard and ADC Options
Figure 7 and Figure 8 on page 16
that are supported by HiGain HDSL2 units when connected to units from other vendors. ADC options are an
extended set of options that are only available when using HiGain units exclusively. For a description of each
option and a list of possible option settings, refer to
to these options:
1 Press C to select the Config menu.
2 Use the and
↑ ↓
3 Use the arrow keys to select an option.
4 Press the SPACEBAR
5 Press ENTER to activate your choice.
H2TU-C-231 List 4E
6) allows you to make the following types of system configuration changes:
(Figure 7 on page 16)
16)
"Setting Date and Time" on page
"Clearing the History, Alarm, and Event Log Screens" on page
Event Log Config
+----------------------+
| Standard Options ->
| ADC Options
| Date and Time
| Master Clear
| Set Factory Defaults |
+----------------------+
09/01/2001 12:30:01
Figure 6. Config Menu
show the Standard and ADC configuration options. Standard options are those
arrow keys to select Standard Options or ADC Options, then press
to cycle through the available settings for that option.
September 28, 2001
13)
"Resetting to Factory Defaults" on page 10
Inventory Report
|
-> |
-> |
|
H2TU-C
Table 5 on page 17 and Table 6 on page
Provisioning
26)
Rlogon Help
System: OK___
18. To make changes
ENTER .
15