Configuring The System; Config Menu - ADC H4TU-C-319 List 1 Line Unit User Manual

LTPH-UM-1031-03, Issue 3

Configuring the System

The Config menu (Figure
•
Standard options
•
ADC options (Figure 8 on page
•
BERT Generator
•
Date and time (see
•
Master clear (see
•
Reset to factory default configuration
Monitor Performance
ID: xxxx--xxxx—-xxxx--xxxx
Making Changes to Standard and ADC Options
Figure 7 and Figure 8 on page 18
supported by HDSL4 units when connected to units from other vendors. ADC options are an extended set of
options available only when using ADC units exclusively. For a description of each option and a list of possible
option settings, refer to
C
1 Press to select the Config menu.
2 Use the ↑ and ↓
3 Use the arrow keys to select an option.
SPACEBAR
4 Press the
ENTER
5 Press to activate your choice.
The message
appears when changing the DS1 Line Coding (DS1) or H4TU-C Equalization (EQL) option in the
Standard Options configuration screen. (This applies when the H4TU-C is used in a
Wideband 3190 which contains a multiplexer.)
H4TU-C-319 List 1
6) allows you to make the following types of system configuration changes:
(Figure 7 on page 18)
18)
(Figure 30 on page 56)
"Setting Date and Time" on page
"Clearing the History, Alarm, and Event Log Screens" on page
(Figure 9 on page
Event Log Config
+----------------------+
| Standard Options ->
| ADC Options
| BERT Generator
| Date and Time
| Master Clear
| Set Factory Defaults |
+----------------------+
02/01/2002 12:30:01
Figure 6. Config Menu
show the Standard and ADC configuration options. Standard options are
Table 5 on page 19 and Table 6 on page
arrow keys to select Standard Options or ADC Options, then press
to cycle through the available settings for that option.
May need to change MUX option after changing this option
September 12, 2003
15)
23)
Inventory Report Rlogon
|
-> |
-> |
-> |
|
H4TU-C
20. To make changes to these options:
Provisioning
24)
Help
System: OK___
ENTER
.
17