Tool Interface - IEMAI HIGH-TEMPERATURE Series Operating Instructions Manual

2.3.2 Tool Interface

Figure 1: Main interface
Click "Tool" to go to Figure 2
Figure 4: Pre-Heat interface
This interface allows you to
1.
set the preheat temperature
of the hot bed, left nozzle
and Right nozzle
Figure 2: Tool Interface
1. Click "Manual" to go to Figure 3
2. Click "Preheat" to go to Figure 4
3. Click "Filament" to go to Figure 5
4. Click "Level"
automatic leveling
5. Click "Fan" to go to Figure 6
6. Click "Stop" to stop all execution
commands
7. Click "More" to
after-sales contact information
Figure 5: Filament interface
1. Loading material "
2. Unload material "
3. E1- Left Nozzle,E2-Right Nozzle
4. " "Stop Loading Command
- 15 -
Print More Materials, All For Application
Here can do the following
1. Select the moving unit of
0.1-10mm
2. Controls the XYZ axis for unit
to perform
movement
3.
Click "
original point"
4. Select E1 or E2 for unit
extrusion
view the
Figure 6: Fan Interface
1. This interface allows you to set
"
the nozzle cooling fan E1,
nozzle cooling fan E2 and the
fan rate of the motherboard
"
fan
Figure 3：Manual
" to go back to the