Filter Function Display; Turn The Spectrum Display Off; Information Displayed On The Scope Screen - Yaesu FT-710 Operation Manual

Filter Function Display

Displays the passband status of the Digital filter. The operation of WIDTH, SHIFT, NOTCH, CONTOUR
etc. can be observed.
SSB Mode
DSP filter bandwidth
Touch the filter display to reveal and check the setting value of the last used function from SHIFT, WIDTH, NOTCH,
CONTOUR, and APF. The setting may be changed by turning the [FUNC] knob of the active function.
Example: When the last function used is the NOTCH function
Touch the filter display to display the NOTCH function setting value.

• Turn the spectrum display OFF

To display only the Digital filter bandwidth information, press and hold the spectrum area of the filter func-
tion display to clear the spectrum view. To display it, press and hold again.

Information displayed on the scope screen

Scope screen information
20
Passband status of DSP filter
(SHIFT, WIDTH)
State of NOTCH State of CONTOUR
CW Mode
CENTER : The receive frequency is always shown at the
CURSOR : Monitors the spectrum within the range set
FIX
SLOW1 : sweep speed
SLOW2 : sweep speed
FAST1
FAST2
FAST3
STOP
SPAN nnnkHz : Scope Screen frequency span (display
RTTY Mode PSK/DATA Mode
center of the screen and spectrum display.
The band spectrum is shown within the range
set by "SPAN". The CENTER mode is conve-
nient for monitoring the signal activity around
the operating frequency.
with "SPAN". When the frequency (marker)
exceeds the upper limit or the lower limit of
the range, the screen is automatically scrolled
and the status beyond the setting range can
be observed.
: Enter the start frequency of the scope.
Slow
: sweep speed Normal
: sweep speed
: sweep speed Fast
: Temporarily hold the operation of DSS dis-
play and waterfall display.
range).
↑
↓