Meter Display
S-Meter
RF power Output
When the meter display screen is touched, the
transmit meter selection screen is shown (the
default setting is "PO").
Touch the meter area
AMC gain control display
(Displays compression level during
speech processor operation)
Make adjustments by pressing the [FUNC] knob
→
→
touch [COMP]
rotate the [FUNC] knob.
RF power Output
Relative ALC voltage
Standing Wave Ratio
Final amplifier drain current
Displays the current operating mode. When
touched the operation mode selection screen is
displayed. Touch the desired operation mode to
select it.
VFO-A: Lights in VFO-A mode.
VFO-B: Lights in VFO-B mode.
M-xx:
→
MT:
QMBxx: Lights up during operation with quick memory.
M-Pxx: Lights up during programmable memory scan
EMG:
This is a warning notification of an
Final amplifier
abnormality in the antenna system.
drain voltage
If "HI-SWR" lights up, immediately check if for
any abnormality in the antenna system.
Operation MODE Display
Touch [PRESET] to display the settings that ap-
ply to the FT8 operation.
Operation status Display
Displays the selected channel number in
memory mode.
Lights up during memory tuning operation.
operation.
Emergency call set frequency call lights up.
HI-SWR Display
17