Use Gui To Control Laser - JPT YDFLP Installation Manual And User's Manual

5.2.2 Use GUI to Control Laser

1) Control Mode Option
When we select all parameters controlled by GUI. The setting will be saved and has data
power-off memory function. Therefore,
when we don't want to use GUI to control the laser.
Laser is able to work at the parameter set by GUI like power, frequency and pulse width.
Laser On: set the parameters you want and click "laser on",the "on" light become green means
laser start. "off" light become green means laser off.
Language: In the English interface, click "中文" will switch to English, in the Chinese interface,
click "English" will switch to English.
2) Default Set of Laser
Laser can set the default parameters through this Default_SET,like SIMMER,Pulse
Width,Repetition Rate and others,any change will work immediately and it support data
Power-Off memory function.
File Number: EFLP001-B-E
we should cancel the GUI_Control mode each time
Shenzhen JPT Opto-electronics Co. Ltd.
18
YDFLP Fiber Laser Installation
Guide and User Manual
Version : V05 Date:2017