Introduction; Functions; Com Port Connection - JPT YDFLP Installation Manual And User's Manual

5.1.2.Introduction

1. JPTlaser GUI has below functions:Laser_Control,Default_SET,Operate Prompt,Feedback
Prompt,Control_Mode,Laser_STA,DB25 Port Monitor,Laser SYS,etc.
2. All setting and change on GUI will work immediately,no need to restart,
3. The "Default_SET" and "Control Mode" have power-off protection function for the
parameter,
4. Only the Power can be adjusted in Laser_Control panel when laser is emitting(Include
DB25 Laser on & GUI Laser on).Otherwise laser will warning as below figure 1,

5.2.Functions

5.2.1 COM Port Connection

Check COM number after connecting the USB cable：
Computer—>Properties—>Hardware—>Device Manager—>
If the COM number is larger than 4, change it to an integer not
exceeding 4.
Choose the COM port on GUI the same as set in the computer,then click "connect".
connect only after the laser get power >= 12s,
File Number: EFLP001-B-E
【Figure 1】
Shenzhen JPT Opto-electronics Co. Ltd.
17
YDFLP Fiber Laser Installation
Guide and User Manual
Version : V05 Date:2017
Please