Table of Contents
Advertisement
Installation
Please note the rear panel of the cabinetry must be removed to ensure adequate
ventilation.
The power switch or socket that connects to the appliance should not be located in the
installation housing, but rather in an adjacent cabinet or above the worktop.
Remarks:
1. Only
+
admissible for all dimensions.
2. Cabinet dimensions do not
include power switch/socket
dimensions.
The panels that are immediately adjacent to the oven must be of a material that has
heat resistant qualities. In particular, cabinets with veneer finishes must be assembled
with glues that can withstand temperatures of up to 100°C. Special attention must be
paid to the edge banding finish on the cabinetry. Special care must be taken with
vacuum applied veneers commonly referred to as "thermowrap". If in doubt, always
refer to the technical data supplied by the kitchen cabinetry manufacturer.
deviations
are
In
order
to
ensure
ventilation, the back of the cabinet
unit must be removed. If the oven
will rest on a continuous panel there
must be an aperture of at least
560mm wide by 45mm deep from the
rear of the cabinet.
adequate
14
Advertisement
Table of Contents
