Sanyo MINI ECO-i SPW-CR365GXH56B Service Manual page 183

7. Communication Adaptor
(SHA-KA128AG(B))
(3) Setting the indoor/outdoor control wire connection on/off
1 Repeat steps 1 to 3 in section (2) "Adaptor number setting procedure" above. The following will display:
2 Press the
key once so the following display appears:
UP
3 Hold down the
key for at least 1 second so the "0" part blinks, indicating that the setting can be changed. (The green and red monitor
SET
LEDs are both on.)
Use the and keys to turn the indoor/outdoor control wire connection on or off as shown in the table below.
UP DOWN
Setting value Indoor/outdoor control wire connection
0 LINK1: On, LINK2: On (factory setting)
1 LINK1: On, LINK2: Off
2 LINK1: Off, LINK2: On
3 LINK1: Off, LINK2: Off
For example, to connect the indoor/outdoor control wire only to LINK1, press the
4 Press the
key for at least 1 second to confirm. (Only the green monitor LED is on.)
SET
(4) Other settings
With the display status showing as in number 3 in section (2) "Adaptor number setting procedure", press the
the setting items shown in the table below. Set as needed.
The setting procedure is the same as above.
(Press the key for at least 1 second, press the
SET
Note
1 When configuring, do not set the same adaptor number more than once.
* Use numbers between 1 and 7 for connecting to an Intelligent Controller.
2 Turn the indoor/outdoor control wire connection on/off as appropriate.
(Set to "Off" for LINKs with no connection.)
3 For connecting the indoor/outdoor control wire to only one link, use the
"LINK1" side.
(1.Ano.03) (When the adaptor number is 3)
(2.Adyu.0) (Factory setting)
(2.AdYu.1)
and
UP DOWN
7 - 123
key once. The following display will result:
UP
keys to change, then press the
SET
Mini ECO-i System
Remote Control Functions
and keys to select
UP DOWN
key at least one second to confirm.)
7