Sanyo MINI ECO-i SPW-CR365GXH56B Service Manual page 118

5. System Controller
(SHA-KC64AG(B))
(1) Press the and
seconds.
and CODE No. C1 will flash.
(2) Select CODE. No. C3 by pressing
press the button.
C3 changes from flashing to ON state and
auto. overlap checking will start.
(3) If C3 changes from ON to flashing and
disappears, there is no overlapping.
Then finally, complete the auto overlap checking mode by pressing
the button.
(4) If some of GROUP No., ZONE No. and UNIT No. flash, you should
try again the zone registration.
1 Select CODE No. C1 by pressing
press the
2 Select the flashing GROUP No. with ZONE and GROUP button.
Then press the
UNIT No.
3 Then finally, complete the auto. overlap checking mode by
pressing the
7
7. How to check overlapping of central address no.
buttons at the same time for more than 4
,
button.
button and reselect the ZONE, GROUP and
button.
( ) button and
will flash. Then
stops flashing and
, ( ) button and
7 - 58
Mini ECO-i System
Remote Control Functions
Fig. 13