Sanyo MINI ECO-i SPW-CR365GXH56B Service Manual page 182

7. Communication Adaptor
(SHA-KA128AG(B))
4
Setting the Communication Adaptor board
The switches on the board control the adaptor numbers, turn the indoor/outdoor control wire connection on and off, and control other settings.
(1) Switch operation overview
1 Item selection
Use the and
UP DOWN
2 Changing the settings
Use the and
DOWN
UP
Hold down the
HOME
lost.)
(2) Adaptor number setting procedure
1 Hold down the
HOME
2 Press the
key five times so the following display appears:
UP
This automatically switches to the below display after 2 more seconds. (Operation is not necessary.)
3 Press the
key so the below display appears. (Only the green monitor LED is on.)
SET
7
4 Hold down the
SET
LEDs are both on.)
Use the and
DOWN
UP
For example, to set number 3, press the
5 Press the
key for at least 1 second to confirm. (Only the green monitor LED is on.)
SET
7-segment LED
HOME
Home key
keys to find the desired item, then press the
keys to change the setting, then press the
key for at least two seconds to reset to the default setting
key for at least two seconds so the initial display shows as follows:
(no.00)
After 2 seconds
(AdP.dt)
(no.05)
(FirSt)
(1.Ano.00) (Factory setting)
key for at least 1 second so the "00" part blinks, indicating that the setting can be changed. (The green and red monitor
keys to set the adaptor number.
key three times. The following will display:
UP
(1.Ano.03)
D8 D7 D6 D5 D4 D3
S6 D1 S7 S8 S9
D2 UP DOWN SET
Monitor LED
D1: red
D2: green
key to select.
SET
key to confirm.
SET
7 - 122
Mini ECO-i System
Remote Control Functions
Set key
Down key
Up key
(Any settings in progress will be