System Requirements - Intermec EasyLan AW02 Quick Start Manual

System Requirements

EasyLAN Wireless can communicate with 802.11b/g devices,
but the connection must be established with negotiated 802.11b
data rates only.
To set up printing through EasyLAN Wireless, you need to
know if you have an ad-hoc or infrastructure network:
• In an ad-hoc network, you need a PC with an 802.11b/g card
or other 802.11b/g device that prints straight to the printer.
• In an infrastructure network, you need an installed 802.11b/g
network that allows devices to print to the printer.
To use 802.1x security and TTLS, you need:
• an authentication server. You can use a PC with the Funk
Odyssey RADIUS server software v1.1 or later. You can
™
use an Intermec MobileLAN
v1.80 or later; for help, see the access point system manual.
Or, you can use a compatible authentication server.
• an authenticator that supports TTLS, such as an Intermec
MobileLAN access point with an 802.11b/g radio and
software v1.80 or later. The authenticator knows the IP
address and secret key of the authentication server and
translates TTLS frames to Remote Authentication Dial-In
User Service (RADIUS) frames and vice versa.
• a printer with EasyLAN Wireless Model AW02 running
firmware version 4.30 or later.
To use 802.1x security and LEAP, you need:
• an authentication server. You can use a PC with the Funk
Odyssey RADIUS server software v1.1 or later. You can use
an Intermec MobileLAN access point with software v1.80 or
later; for help, see the access point system manual. You can
use a Cisco 1230, 1231, or 1300 access point as a LEAP
authentication server as well as the authenticator.
• an authenticator that supports LEAP, such as a Cisco 1200
series or Cisco 350 series access point with an 802.11b/g
radio.
• a printer with EasyLAN Wireless Model AW02 running
firmware version 4.30 or later.
EasyLAN Wireless Quick Start Guide
access point with software
™
7