Installation Instructions - Intermec EasyCoder PF2i Install Manual

Chapter 1 — Physical Installation

Installation Instructions

• Switch off the printer and disconnect the power cord.
• Disconnect all communication cables.
• Remove the bottom plate as follows.
The electronic compartment contains wires and compo-
nents with dangerous voltage (up to 380V). Make sure that
the printer is switched off and the power cord is discon-
nected before bottom plate is removed.
• Turn the printer upside down on a soft cloth or similar to avoid
scratches.
• Using a #T20 Torx screwdriver, remove the six screws indicated below
and lift away the bottom plate and right-hand door assembly.
2 Label Taken Sensor Kit – Installation Instructions