Table of Contents
Advertisement
Echoflex Installation Guide
Wall Switch Sensor
Range Confirmation
The Range Confirmation test quantifies the strength of the wireless signal
to a linked controller that has range confirmation capability.
Note:
test properly. Disable repeaters that are in range.
1. Press and hold the [Teach] button until all the LEDs blink once.
Release the button to enter the menu and display the first item, the
blinking red LED.
2. Press and release the [Teach] button to cycle through the menu of
color LEDs and stop when the yellow LED is blinking.
3. Press and hold the [Teach] button until the LED stops blinking to
initiate the Range Confirmation test.
After the OWS transmits and receives a Range Confirmation message,
the signal strength status is displayed as an LED blink color.
Green
Yellow
Red
No LED
The test repeats every five seconds and runs for 50 seconds. To exit
before the time-out, press and hold the [Teach] button.
LED Display
The LED Display setting enables or disables the LEDs. Blinking LEDs are
informative but not suitable for every location.
1. Press and hold the [Teach] button until all the LEDs blink once.
Release the button to enter the menu and display the first item, the
blinking red LED.
2. Press and release the [Teach] button to cycle the menu of color LEDs
and stop when the green and red LEDs are both blinking.
3. Press and hold the [Teach] button until the LEDs stop blinking to
select LED Display.
4. Press the [Teach] button to toggle between the two states:
Red LED blinking - enable LEDs for motion detection
•
Green LED blinking - disable LEDs for motion detection
•
5. Press and hold the [Teach] button for five seconds to save and exit.
Wall Switch Sensor
Only one controller can be linked to the OWS to run the
LED Blink
Signal Strength
-41 to -70 dBm (best)
-70 to -80 dBm (good)
-80 to -95 dBm (poor, move closer)
No linked controllers detected
Page 8 of 12
Echoflex
Advertisement
Table of Contents
