Table of Contents
Advertisement
OLIVE HARVESTING SHAKER RAKE OLIVION POWER 48 P230 / T220-300
Fitting
1.
Insert the new prong (1) into its slot.
Align the prong groove with the notch on the inside
of the rake support so that the prong is locked in
position and no longer rotates.
2.
Using a screwdriver, insert the new washer (2).
3.
Using a torque screwdriver and a TORX 20 bit, tight-
en the new prong fastening screw.
Important
Tightening torque: 1 N.m
4.
Proceed in the same manner for each rake prong.
5.
Fit the rake supports in position (3) on the vibrating
head.
6.
Screw in the four screws (4).
7.
Torque tighten the screws (4).
Important
Tightening torque: 5 N.m
28
48_151649-F
Advertisement
Table of Contents
