Table of Contents
Advertisement
OLIVE HARVESTING SHAKER RAKE OLIVION POWER 48 P230 / T220-300
Fitting
1.
Insert the new prong (1) into its slot.
Align the prong groove with the notch on the inside
of the rake support so that the prong is locked in
position and no longer rotates.
2.
Using a screwdriver, insert the new washer (2).
3.
Using a torque screwdriver and a TORX 20 bit, tight-
en the new prong fastening screw.
Important
Tightening torque: 1 N.m
4.
Proceed in the same manner for each rake prong.
5.
Fit the rake support on the vibrating head.
6.
Using a 4mm Allen key, fit the screws under the rake
support.
7.
Tighten the screws.
Important
Tightening torque: 5 N.m
6.4. REPLACING THE RAKE PRONGS ON THE DUO VIBRATING HEAD
Caution
Before making any adjustments to the tool, make sure it is turned off and disconnect the
power cord connected to the battery.
26
48_151649-F
Advertisement
Table of Contents
