Unplug the unit
1
Failure to disconnect power
from the unit before servicing
could result in severe bodily
injury or death. The ON/OFF
Switch does not disconnect
incoming power to the unit.
Refer to Crown Removal steps. Page 18.
2
Remove top cover by removing (4) screws. There are
3
(2) screws on each side of the unit.
Cut (4) zip ties.
4
527-504revM_EN
Remove/Replace High Limit Switch
WARNING
Remove (2) main platen bolts.
5
Remove intermediate support from platen. This will
6
include (2) screws, (4) spacers, and (1) heat guard.
Remove (4) 3/8" nuts on left side of unit to release the
7
(4) springs.
Standing from the rear side of the unit, slide the platen
8
to the left, until the probe cover is revealed.
33
Vertical Toaster
DCFT-MCD Series
Printed in USA 12/20 © 2020