Adjusting The Label Gap Sensor - Intermec EasyCoder 4420 User Manual

Chapter 5 — Optimizing Printer Performance

Adjusting the Label Gap Sensor

54
To move a label format forward with the TOF switch
You notice that the format is printing toward the back part of the label.
1 Remove the media cover.
Note: Do not raise the printhead while adjusting the TOF position.
2 Press on the front part of the TOF switch. Each time you press the
TOF switch, you move the label format forward 0.127 mm (0.005 in).
3 Press the TOF switch repeatedly until the format moves forward to the
correct position on the label.
If you experience problems such as the printer skipping labels or the
printer stopping and the yellow LED flashing, you may need to adjust the
label gap sensor. You are most likely to experience any of these problems if
you are using very narrow label stock and the label gap sensor is not in the
correct position. You can adjust the label gap sensor from 0 to 2.5 cm (0
to 1.0 in) from the inner edge of the printer.
EasyCoder 4420 and 4440 Bar Code Label Printer User's Manual
Label direction from printer
44XXU057.eps
Label direction from printer
44XXU060.eps