Table of Contents
Advertisement
Web screen configurations (continued)
z NDI|HX V2
„
Make NDI|HX V2 transmission settings.
The setting is confirmed with the [Set] button.
NDI|HX V2
<NOTE>
• This unit restarts when [Streaming mode] is changed to [NDI|HX
V2], or when changed from [NDI|HX V2] to another mode.
Source name
Sets the device name displayed when this unit is detected by software
applications and hardware compatible with NDI|HX.
Factory settings: NDI_Device-[serial number of this unit]
Maximum number of
1 to 32 characters
characters
Characters that can be
Alphanumeric characters, symbols:
entered
Protocol [TCP, UDP]
Sets the format of unicast transmission to be used.
Factory settings: TCP
Multicast Transmit [On, Off]
Sets whether to perform multicast transmissions of images for
software applications and hardware that are compatible with NDI.
Factory settings: Off
Address(IPv4) [IPv4 : 244.0.0.0 to 239.255.255.255]
Enter the multicast IP address.
Images and audio are transmitted to the specified multicast address.
Factory settings: 239.192.0.30
<NOTE>
• Check the multicast IP addresses available for use before
entering.
Subnet(IPv4)
Enter the subnet mask.
Factory settings: 244.0.0.0
<NOTE>
• [Address (IPv4)] and [Subnet (IPv4)] clarify the multicast address
ranges randomly set during multicast transmissions.
• When [Address (IPv4)] is set to [239.255.0.0] and [Subnet (IPv4)]
is set to [255.255.0.0], the selection is made randomly in the range
between [239.255.0.0] and [239.255.255.255].
• To use the IP address set in [Address (IPv4)], set [Subnet (IPv4)]
to [255.255.255.255].
TTL/HOP Limit
The same as the H.264 [Multicast TTL/HOPLimit] (→ page 93) .
Group [Enable, Disable]
Sets whether to use the grouping function when performing NDI
transmission.
Factory settings: Disable
Name
Sets the group name for use when the grouping function is used.
Maximum number of
characters
Characters that can be
entered
Use discovery server
Sets whether to use the discovery server when performing NDI
transmission.
Server address(IPv4)
Sets the IPv4 address of the server when using the discovery
server.
Streaming format
- _
Make settings for H.264 images used for NDI|HX V2 transmission.
Confirm the settings with the [Set] button.
Refer to the description of H.264 (→ page 92) for information about
[Image capture size], [Frame rate], and [Max bit rate(per client)].
97
1 to 32 characters
Alphanumeric characters
Advertisement
Chapters
Table of Contents
