Panasonic AW-HE145WP Operating Instructions Manual page 16

Parts and their functions (continued)
10.
RS‑422 connector <RS‑422>
This RS-422 connector (RJ-45) is connected when exercising serial
control over the unit from an external device. Use a cable with the
following specifications for the connection to this connector.
Furthermore, by shorting the R-TALLY signal (2-pin) with the GND
(1-pin), it is possible to light the tally lamp (red) in the camera head
section of the unit.
<NOTE>
• Do not connect PoE cable to the RS-422 port.
• Do not apply a voltage to the R_TALLY_IN signal pin.
• Menu settings enable the output to pin 7 and pin 8 of the red tally
and green tally signals received by the unit. Output is by contact
output, and normally is "OPEN", then it becomes "MAKE" for output.
(→ page 59)
LAN cable (category 5e or above, STP, straight cable),
1
*
max. 1000 m (3280 ft)
* 1
Use of an STP (shielded twisted pair) cable is recommended.
Pin
No.
1
2
3
4
„ Example OPTION_OUT1, OPTION_OUT2 connector
connections
AW-HE145
OPTION_OUT1
OPTION_OUT2
GND
Pin
Signal Signal
No.
GND 5 TXD+
R_TALLY_IN 6 RXD+
RXD– 7 OPTION_OUT1
TXD– 8 OPTION_OUT2
Voltage: Maximum DC12 V
Current: Maximum 100 mA
11.
Service switches <SERVICE>
Perform switch settings before turning the unit on.
LAN
LINK ACT
RS-422
12 V IN
IR ID
AUDIO IN
Function
SW1 Switches for initialization
(Refer to the explanations in "Initialization 1"
and "Initialization 2")
SW2
Always leave at OFF (used for factory
SW3
adjustments)
SW4
Initialization 1
• Reset the user authentication settings and host authentication
settings for network connection.
(This will delete all the registered user information (IDs/passwords)
and host information (IP addresses).)
• With the IR ID switches and service switches set as shown below,
turn on the power of the unit.
<NOTE>
• When initialization is complete, the status display lamp on the
front of the unit blinks green. Set the service switches back to their
original positions (SW1 to SW4 all OFF), then restart the unit.
Initialization 2
• The unit is reset to the state it was in at the time of purchase. (All
camera menu setting values and network setting values are reset.)
• With the IR ID switches and service switches set as shown below,
turn on the power of the unit.
<NOTE>
• When initialization is complete, the status display lamp on the
front of the unit blinks green. Set the service switches back to their
original positions (SW1 to SW4 all OFF), then restart the unit.
12.
HDMI connector <HDMI>
This is the HDMI video output connector.
13.
3G SDI OUT connector <3G SDI OUT>
This is the 3G SDI video signal output connector.
16
SERVICE
3G SDI OUT G/L IN
Service switches
Factory settings
SW1 SW2 SW3 SW4
ON
OFF
SW1 SW2 SW3 SW4
ON
OFF
OFF
OFF
OFF
OFF