Panasonic AW-HE145WP Operating Instructions Manual page 121

Web screen configurations (continued)
z mDNS
„
By setting an mDNS [Host name], it is possible to access this unit via
http://Host name.local.
Maximum number of
63 characters
characters
Characters that can
Alphanumeric characters, symbols : -
be entered
Factory settings: panasonic-ptz
<NOTE>
• Proper operation cannot be guaranteed if there is another camera with
the same settings in the same network.
z 802.1X
„
Makes settings for the IEEE 802.1X client.
<NOTE>
• You will require 802.1X knowledge in order to complete the settings.
Consult the network administrator for details.
• It is necessary to make settings for an authentication server and
Authenticator separately when building a system that uses this
function.
Consult the network administrator for details.
• In a system configuration where 802.1X is enabled, it is not possible to
control the camera from AW-RP150 or AW-RP60.
• Before setting, go to either the [Date&Time] settings screen or the
[NTP] settings screen to set the time for this unit.
Proper operation may not be possible if the time has not be set
correctly for the unit.
• Before setting, in the [Date&Time] settings screen, set [Memory] to
[Enable].
802.1X [On, Off]
Sets whether to use the 802.1X function.
Factory settings: Off
EAP authentication method [TLS, PEAP]
Makes settings for the authentication method used for the 802.1X
function.
This unit supports authentication methods using TLS or PEAP.
Factory settings: TLS
<NOTE>
• Proper operation may not be possible if it does not match the
authentication method permitted by the authentication server.
TLS
Makes settings for when the TLS authentication method is used.
Client certificate type [PEM, PKCS#12]
Makes settings for the client certificate method used with TLS
authentication.
This unit supports the PEM and PKCS#12 methods.
<NOTE>
• When a private key is to be used, the private key information must be
included in the client certificate.
Set [Private Key password usage] to [Enable] and set the correct
password.
• When installing a client certificate with the PKCS#12 method, it is
necessary to set [Private Key password usage] to [Enable] and to set
the correct password.
• If the PKCS#12 method is selected, the PKCS#12 password and the
[Private Key password] need to match.
Private Key password usage [Enable, Disable]
Sets whether to use a private key in the client certificate.
Enable Select when a private key is to be used.
Disable Select when a private key is not to be used.
<NOTE>
• If [Enable] is selected, the correct value needs to be set for [Private
Key password].
Private Key password
Makes settings for the password set in the private key.
<NOTE>
• When installing a PKCS#12 method client certificate, enter the same
password as the one set for PKCS#12.
TLS User name
Sets a user name permitted by TLS authentication.
<NOTE>
• Consult the network administrator regarding valid user names.
Client certificate install
Installs the client certificate.
<NOTE>
• The client certificate installed must be the correct one issued by the
certificate authority.
• Before installing the certificate, check that the settings for [Client
certificate type], [Private Key password usage], and [Private Key
password] have been completed.
The certificate may not be installed correctly if the above settings have
not been completed.
121