Ram Backup; Exit (Return To Supervisor Mode) - Intermec M90 Series Reference Manual

M90 Series Portable Data Entry Unit Reference Manual

7. RAM BACKUP

Select option 7.RAM BACKUP from the Diagnostic menu for the RAM
back up test screen. Press [0] to return to the Diagnostic menu, or press
[1] to continue with the memory flush.
!! WARNING !!
Will Flush RAM &
RAM Disk !
Continue ?
1=YES/0=NO
If you pressed [1] to continue, the following instructions appear:
RAM Backup TEST
Wait 30 seconds
After power off,
Then turn it on
Again
Press any key to
Turn it off . . . _
Remove the battery pack from the M90 to turn the unit off, wait 30 sec-
onds, reinsert the battery pack, then turn on the M90. A "Please Wait"
message appears on the display, followed by this pass/fail screen:
RAM Backup TEST
PASS !
Press any key to
Continue . . . _

8. EXIT (Return to Supervisor Mode)

Press option 8.EXIT from the Diagnostic menu to return to the Ready
Mode. The M90 then performs a warm start. If the M90 memory was
tested, the M90 performs a cold start.
—
Chapter 3 Operation Modes
45