Option B: Non-Dhcp Environment; Importing The Hpe 3Par Vsp Into Hyper-V; System Requirements - HP HPE 3PAR StoreServ 8000 Installation Manual

Option B: Non-DHCP Environment

To set the IP address of the VSP:
1. In the VMware vSphere Client window, select the Console tab, click anywhere on the screen,
and press Enter.
2. Log on as setupusr. Press Enter.
A password is not required to configure the network settings.
3. Enter the SP IP address and press Enter.
4. Enter the Netmask address and press Enter.
5. Enter the default gateway address and press Enter.
6. Enter Y to configure the network and press Enter.
7. Review the configuration confirmation and record the VSP IP address for reference during
subsequent setup procedures with 3PAR SmartStart or the 3PAR Service Processor Setup
Wizard.
8. Press Enter to exit.
9. Press Ctrl-Alt to release the cursor.
10. Continue on to
3PAR SmartStart over the public network. If you are not using 3PAR SmartStart, see
"Installing HPE 3PAR Storage Software When HPE 3PAR SmartStart is Unavailable" (page
127).
NOTE:
repeat this procedure before continuing to the SP configuration.

Importing the HPE 3PAR VSP into Hyper-V

This section describes the prerequisites and procedures for importing the VSP into Hyper-V.
WARNING!
the VSP manages, because it might lead to the inability of properly managing the array when
connectivity to the storage is unavailable.
Provision the VSP on a Hyper-V server and ensure that the VSP boots from the local disk of the
assigned Hyper-V server, not from the 3PAR StoreServ 8000 Storage LUNs.

System Requirements

Host operating system requirements:
NOTE:
◦
Microsoft Windows Server 2012 R2 (Standard or Datacenter Edition)
◦
Microsoft Windows Server 2008 R2 (Standard, Enterprise, or Datacenter Edition)
◦
Microsoft Windows Server 2012 (Standard or Datacenter Edition)
Processor requirements:
◦
x86-64 processor version
◦
Hardware-assisted virtualization support
NOTE:
such as Intel VT or AMD Virtualization (AMD-V).
"Service Processor and System Setup" (page 98)
This network configuration is temporary. If the VSP is rebooted, you will need to
Do not install the VSP on the same 3PAR StoreServ 8000 Storage system that
Hyper-V is supported only on x86-64 versions of Windows Server.
This support is available in processors that include a virtualization option,
to set up the VSP with
Importing the HPE 3PAR VSP into Hyper-V 93