Sp Wizard Step 1-Welcome - HP HPE 3PAR StoreServ 8000 Installation Manual

SP Wizard Step 1—Welcome
The Welcome page shows the information that is required to complete the wizard and set up
the SP.
The setup takes about 15 minutes.
1. Obtain the following information:
3PAR StoreServ Storage 10-digit serial number
NOTE:
configuration. The 3PAR StoreServ 8000 Storage no longer has a 7-digit serial number,
but uses instead a 10-character serial number for configuration.
This requires up-to-date versions of HPE 3PAR SP and VSP software and of 3PAR
SmartStart.
SP network configuration:
◦
◦
◦
◦
Remote support:
◦
Time and region:
◦
◦
2. Click Next to proceed to the next wizard step.
Legacy 3PAR StoreServ Storage systems used 7-digit serial numbers for
The name to be assigned to the SP
IP address (IPv4 only)
Subnet mask and gateway, if you are using custom settings
DNS settings
CAUTION: Do not enable DNS settings while you are initializing the system
software; the system will fail. See
(page 130)
You may need DNS settings later if you want to verify remote support connectivity.
To configure DNS settings manually after you have completed software initialization,
see "Service Processor Initialization" (page 90)
Proxy server settings (optional)
The current date and time or NTP server IP addresses, if you plan to use automatic
date/time configuration
Time zone region (for example, America/Los Angeles)
"3PAR StoreServ Storage Detection Issues"
HPE 3PAR Service Processor Setup Wizard 101