Intense M 2022 Series Manual page 14

A
C
D
26
B
E
F
S T E P 8
ADJUST HEADSET
& HANDLEBARS
If your headset feels a little loose, undo the three pinch
bolts on the top crown of your forks with a 4mm Allen
key (A,B,C). Two of the pinch bolts are located on the
forward-facing surface and the third bolt is located on
the back side near the steerer tube.
With a 5mm Allen key set the headset preload by gently
tightening the top cap bolt by a quarter clockwise turn
(2-4Nm) (D). Retighten the stem clamp bolts and check
the headset again. If the bars don't turn smoothly it is
too tight, so repeat the process, but this time slacken
the top cap bolt off a little, or if it is too loose, continue
to tighten. Once tight go back and tighten the three
pinch bolts on the top crown to 7Nm (E,F).
27