U S E R M A N U A L
3.2.3 Rack mount installation
3.2.3.1 UPS
Note that you need a rack-mounting kit
(purchased separately) for this operation. This
procedure is suitable for 19-inch rack cabinet
installation with a minimum depth of 800 mm.
Identify the final position and keep 2U spacing
for this installation.
1. Install the ear bracket onto the unit using the
M4 flathead screws (figure 1).
2. Slide the unit into the rail kit and make sure to
tighten the rack-mounting screw (figure 3).
If installing additional UPS units, repeat the
steps above for each cabinet.
—
01
—
01
—
—
01
01
Ear bracket
—
—
02
02
Rack rails
—
02
—
02
—
03
Rack mount installation
—
03
—
03
—
3 I N S Ta L L aT I O N
3 .2 .3 .2 External battery modules
—
04 Battery module
3.2.3.2 External battery modules
Identify the final position and keep 3U spacing
connection
Identify the final position and keep 3U spacing
—
for this installation; it is recommended that this
05 Display rotation
for this installation; it is recommended that this
spacing is provided below the UPS.
—
06 Stabilizer bracket for
spacing is provided below the UPS.
external batter module
1. Install the ear bracket onto the unit with the
1. Install the ear bracket onto the unit with the
flathead M4 screw. (figure 1).
flathead M4 screw. (figure 1).
2. Slide the unit into the rail kit and make sure to
2. Slide the unit into the rail kit and make sure to
tighten the rack-mounting screw (figure 3).
tighten the rack-mounting screw (figure 3).
3. Connect the EBM to the UPS with the battery
3. Connect the EBM to the UPS with the battery
power cable (figure 4).
power cable (figure 4).
—
04
Battery module connection
—
04
NOTE!
NOTE
NOTE!
NOTE
Up to four external battery
UP TO FOUR EXTERNAL BATTERY
enclosures can be connected to the
ENCLOSURES CAN BE CONNECTED TO
THE UPS IN THE SAME WAY AS
UPS in the same way as shown
SHOWN ABOVE.
above.
AFTER CONNECTING THE BATTERY
ENCLOSURES, CONFIGURE THE NUMBER
OF BATTERY MODULES IN THE CONTROL
After connecting the battery
PANEL (FOR MORE INFORMATION SEE
enclosures, configure the number
CHAPTER 4.6.7). SEE APPENDIX C FOR
of battery modules in the control
FURTHER DETAILS.
panel (for more information see
chapter 4.6.7). See appendix C for
further details.
11
3 .2 .4
3 .2 .4 .1
1. Set up
into th
—
05