Rear View; Start Up And Installation - ABB DPA 250 S4 Operating Manual

32 D PA 2 5 0 S 4 5 0 - 2 5 0 K W O P E R AT I N G M A N U A L
5.1.2
—

5.1.2-1: Rear view

NOTE
I/O PORTS
LED's
BUTTONS
5.1.3
When the UPS is energized, the display automatically turns on. It is initiated for a few seconds and sub-
sequently the user is directed to the mimic diagram screen.
Rear View
PLEASE NOTE THAT THE EMERGENCY SHUTDOWN FUNCTION BY PRESSING THE BUTTONS ON/OFF 1 +
ON/OFF 2 IS DISABLED
SD Card Slot for the SD card
USB USB connector
DC Input Power supply connector (only needed if the RJ-45 cable is >75 & <100m)
UPS Input
RJ-45 connector
GREEN: when the UPS is on inverter mode
UPS Status
RED: when the inverter is on alarm
OFF: if no alarm present
Alarm
RED: if unread alarm(s) present
Reset Press the "Reset" button to reset the remote panel
Press "ON/OFF 1" + "ON/OFF 2": Function disabled
ON/OFF 1/2 Press "Reset" + "ON/OFF 1" buttons simultaneously, then release "Reset"
and hold the "ON/OFF 1" button for 10 seconds: Touch screen calibration

Start up and installation

—
5.1.2-1