Atdec AWMS-2-BT75-FS Installation Manual page 3

4. Attach VESA Plates to Displays
4.1 VESA mount compatibility
75mm
100mm
5. Mount Bottom Display
5.1 Set VESA plate to open
position.
Bottom Display must be
mounted on bracket first.
Use two people for wide or
heavy display.
OPEN
5.4 Set VESA Plate to closed
position by sliding clips on
both sides inwards
CLOSED
4.2 Attach VESA Plate
with M4x10 screws.
NOTE
For 75mm VESA
unscrew 5mm to
access top holes
5.2 Lift display until Vesa Plate
is above the Bracket.
5.5 Adjust Display tilt angle by
gripping edges of screen and
rolling up or down to desired
position. .
TOP
5.3 Centre VESA close to post
and slowly lower until bar on
VESA Plate sits in saddle in
bracket.
OPEN
WARNING
Do not loosen
hand knob once
display mounted.
OR For recessed VESA use 10mm
Spacers and M4x20 screws.
E
L
5.6 Set Display angle by
tightening Tilt Knobs.
TILT KNOBS
AWMS-2-BT75-FS Page 3 of 4
E
M
N