Download Print this page
Atdec AWMS-2-BT75-FS Installation Manual

Atdec AWMS-2-BT75-FS Installation Manual

Freestanding hd dual vert

Advertisement

Quick Links

Freestanding HD Dual Vert
COMPONENT CHECKLIST
Bridge
(x1)
F
6mm
Hex Key
(x1)
A
K
Post
Post Cap
(x1)
(x1)
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! Each Bracket supports a maximum weight as per above weight range specification.
! This product supports VESA mounting hole configurations: 75x75mm and 100x100mm.
! The manufacturer accepts no responsibility for incorrect installation.
! VESA mounted accessories (such as mini PC brackets and mounts), and offset VESA locations exert additional leverage that can
exceed the capacity of the mount even though the monitor weight may be within the stated range. Please contact Atdec if you would
like further information.
! WARNING Death or serious injury may occur if a child climbs on or tips product. Anchor product if applicable. Never place product in
an unstable location. Never place remote control or toys on top of monitors.
B
C
Leg
(x2)
G
M8x30mm
M8 Nut
Cap Screw
(x4)
(x4)
L
M4x10 Screw
M4x20 Screw
(x8)
(x8)
M6x6
Button Head Screw (x2)
D
Bracket
(x2)
H
I
M8 Washer
(x2)
M
N
10mm Spacer
(8x)
Installation Guide
AWMS-2-BT75-FS
REQUIRED TOOLS
E
• Phillips Head Screwdriver
VESA Plate
(x2)
CAPACITY
J
Flat Monitor
M8x80
0 - 25kg (0 - 55lb)
Cap Screw
(x2)
Curved Monitor
0 - 18kg (0 - 39lb)
Display Size
17" - 55"
300mm (12") max overall
display depth
AWMS-2-BT75-FS Page 1 of 4
M6 Washer (x2)

Advertisement

loading
Need help?

Need help?

Do you have a question about the AWMS-2-BT75-FS and is the answer not in the manual?

Questions and answers

Summary of Contents for Atdec AWMS-2-BT75-FS

  • Page 1 ! VESA mounted accessories (such as mini PC brackets and mounts), and offset VESA locations exert additional leverage that can exceed the capacity of the mount even though the monitor weight may be within the stated range. Please contact Atdec if you would like further information.
  • Page 2 Never loosen knob while then lower bracket. display is on bracket. Fit Post Cap. TIGHTEN NOTE Set spacing between bottom of ≥ HEIGHT brackets to be equal to SCREEN - or slightly more than - display height AWMS-2-BT75-FS Page 2 of 4...
  • Page 3 5.4 Set VESA Plate to closed 5.5 Adjust Display tilt angle by 5.6 Set Display angle by position by sliding clips on gripping edges of screen and tightening Tilt Knobs. both sides inwards rolling up or down to desired position. . TILT KNOBS CLOSED AWMS-2-BT75-FS Page 3 of 4...
  • Page 4 No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd. Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. ©20220905 AWMS-2-BT75-FS Page 4 of 4...