No Vod Adjustments; Jet Shut Down Incomplete; Over Speed (Print Go) - EC-PACK EC-JET 1000Pro Manual

The following pages describe the System Warnings, together with the actions to be taken (if any).

3.00 No VOD Adjustments

9.4.1
This warning can occur when the jet is being started, or when the jet has been running for some time.
Possible causes
● Printhead code values are set incorrectly:
Check the Printhead and Modulation values printed on the print head serial number label found on the
conduit, with the stored values. (see "hanging the System Setup").
● Ink viscosity is excessively out of range:
Allow the printer to run to bring the viscosity back into range.
● There is a pressure loss in the system:
Call your local EC-JET distributor.

3.01 Jet Shut Down Incomplete

9.4.2
This indicates that the printer was previously switched off while the jet was running or before the printer
had completed the shutdown routine. Completion of the shutdown routine is important and must be
allowed to finish.
The warning does not stop the printer from functioning. It will be reported at every subsequent printer
start-up until a jet shutdown routine is fully completed. Press the [stop] key and wait for the message:
"Jet Stopped: You May Now Switch Off "

3.02 Over Speed (Print Go)

9.4.3
This indicates that the printer may have missed printing at least one pattern or is receiving false triggers
from the photocell.
When the Photocell Mode is set to Trigger, each print delay is started following the photocell trigger.
At the end of the delay a "print go" is issued to start printing. If the printer has not printed the last pattern
by this time, the warning is reported and the new pattern is not printed. In effect, this will mean that
alternate objects will NOT be printed on.
The warning applies to the currently printing pattern is reset automatically when printing is restarted.
Possible cause
Guangzhou EC-PACK Packaging Equipment Co., Ltd.
EC-JET 1000Pro Continuous Inkjet Printer
82