Controls And Indicators; Getting Started; Installation - EC-PACK EC-JET 1000Pro Manual

Controls and Indicators

3.

Getting Started

3.1
This section of the manual is intended to help you understand the setting-up of the printer and tells you
how to switch it on, program a simple message, start the printer jet, print the message and stop the
printer.
Apart from familiarizing you with the machine and some of the most frequently used software, it will
enable you to verify that all is well and the printer and accessories have reached you in good condition.

Installation

3.2
The printer should always be installed by a fully trained, EC-JET approved, service engineer. Guarding
and safety interlocks should all be in place and working correctly. EC-JET can accept no liability for
damage to either machine or personnel in the event of the printer being installed, moved or maintained by
unauthorized and/or untrained personnel.
If the printer is relocated or changes to the production line are made, information on how to install and set
up the printer can be found in "Appendix 1: Installation and Setting Up".
EC-JET printers can be fit to a single-phase 50/60 Hz AC power supply of 115V or 230 V.
Switch on the right voltage before power on, the shift button can be found as the picture shows:
There are two types of power supply:
115V for the range of 85-132Vac, 50/60Hz
230V for the range of 170-264Vac, 50/60Hz
NOTE: Disconnect the power supply plug before your switch on. Use a flat screwdriver to
switch.(the figures shown on the PSU value )
Input current: < 2.00A@115Vac， < 1.20A @ 230Vac
Guangzhou EC-PACK Packaging Equipment Co., Ltd.
EC-JET 1000Pro Continuous Inkjet Printer
16