Bad Print Head Code; New Print Head Fitted; Charge Calibration Range; Safety Override Detected - EC-PACK EC-JET 1000Pro Manual

printing is restarted.

3.08 Bad Print Head Code

9.4.9
At start up the software checks the type of print head that is fitted. If it does not recognize the print head
type this warning is reported.
The system will continue to operate on the assumption that the print head has not been changed, and will
continue with the same print head type as used previously (i.e. the currently stored NVR print head type).
If a new type of print head has been fitted, but has not been detected correctly, the modulation frequency,
voltage, etc., will all be incorrect. Therefore, the jet will not break up properly, and a phase fault (2.02) will
probably occur when starting the jet.

3.09 New Print Head Fitted

9.4.10
At start up the software checks the type of print head fitted. The last print head type used is stored in the
printer¡ ¯ s memory.
If the currently fitted type is not the same as the type stored in the memory then this error is reported and
the type in memory is updated.
This warning should only ever occur when a new print head is fitted. If it occurs at other times then the
memory may be corrupt, or the print head connector faulty.
Under normal circumstances this warning just confirms that the print head type has been changed. The
defaults for VOD, modulation, etc., will be used, until the user enters a new print head code in the SETUP
menu.
If the wrong type of print head has been detected for any reason, the modulation frequency, voltage, etc.
will all be incorrect. Therefore, the jet will not break up properly, and a phase fault (2.02) may occur when
starting the jet, or poor print quality may result.

3.10 Charge Calibration Range

9.4.11
Contact your local EC-JET distributor if this error is reported.

3.11 Safety Override Detected

9.4.12
This warning message alerts the user when the safety override link is fitted.
WARNING: DO NOT START THE PRINTER WHEN THIS ERROR MESSAGE IS PRESENT.
PRINTER SAFETY CIRCUITS AND SENSORS WILL NOT BE FUNCTIONING. IN THE EVENT OF
THIS ERROR MESSAGE OCCURRING, SWITCH OFF THE PRINTER AND CONTACT YOUR LOCAL
EC-JET DISTRIBUTOR IMMEDIATELY.

3.12 Low Pressure

9.4.13
When start to jet, the printer has detected a loss of ink pressure, which will affect the printer's
performance.
Possible causes
● The main ink filter is blocked.
● Pump output is low.
Contact your local EC-JET distributor.
Guangzhou EC-PACK Packaging Equipment Co., Ltd.
EC-JET 1000Pro Continuous Inkjet Printer
84