Internal Spillage Fault; System Warnings - EC-PACK EC-JET 1000Pro Manual

Midi 8 hours
This prevents the ink from running out completely if the user fails to top up the ink reservoir following an
"Ink Low" error (see System Warning "3.03"). This failure only occurs when the jet is running since the jet
cannot be started when the ink is low.

2.16 Internal Spillage Fault

9.3.9
This may occur either at switch on, or during normal running. A sensor within the ink system detects the
unwanted presence of ink or solvent within the cabinet tray.
Possible causes
● The ink or solvent tanks have been overfilled.
● A leak has developed within the ink system.
● A Lure fitting has become loose on the main filter or damper.
To cure the fault, the cause needs to be rectified and the ink tray completely cleaned and dried. Contact
your local EC-JET distributor.

System Warnings

9.4
System Warnings inform the user of problems which may affect the operation of the printer but are not
serious enough to require a shutdown.
When a System Warning occurs, a message is displayed on the screen status line for a minimum time of
approximately 3 seconds.
The internal alarm buzzer is sounded twice and the alarm relay activated twice (if enabled) using 1
second pulses.
The error will remain on display after the 3 second interval until the user presses any key, or another error
occurs, or a warning message is displayed, e.g.:
All warnings and faults are logged and may be displayed by selecting
screen which displays all errors that have occurred:
Guangzhou EC-PACK Packaging Equipment Co., Ltd.
EC-JET 1000Pro Continuous Inkjet Printer
81
and then