Adjusting Ref. Information; Print Height; Scale Height; Print Width - EC-PACK EC-JET 1000Pro Manual

Meter Counter

Adjusting Ref. Information

6.1

Print Height

6.1.1
Allows the user to select a suitable print height for optimum print quality.
This range can be tuned to individual requirements, by adjusting the print height over a range of -30% to
+30%.

Scale Height

6.1.2
This enables a greater print height range and can be used to eliminate deflector plate/gutter clipping at
maximum and minimum drop deflection.

Print Width

6.1.3
Minimum width (i.e. the fastest the printer can print) is 0. The width of printed characters may be
increased by increasing the stored value. When used in conjunction with Shaft Encoder "On" the width is
equivalent to shaft encoder pulses between raster.

Print Delay

6.1.4
This is the delay between prints (Photocell Off/Enable) or the delay between the photocell triggering and
print appearing on the product (Photocell Triggered).
NOTES:
1. Too small a delay may result in a "3.02 Over Speed (Print Go)" or "3.04 Variable Data" warnings.
2. Minimum width and delay settings are interactive to allow sufficient time between printing for
Phasing and VOD to occur.

Print Interval

6.1.5
On entering a value less than the minimum against the Print Delay option (for example: 16), the following
message will be displayed: "Value not set: too small"

Print Count

6.1.6
This display shows the number of products printed so far. To reset or change this value, type in the
required number.

Reverse Message (Vertical)

6.1.7
The print must be stopped to change this option.
Off: the message will be printed as on the display.
On: the message will be printed rotate 180° vertically.

Reverse Message (Horizontal)

6.1.8
Off: the message will be printed as on the display.
On: the message will be printed rotate 180° horizontally.
Guangzhou EC-PACK Packaging Equipment Co., Ltd.
EC-JET 1000Pro Continuous Inkjet Printer
Change Password
53
Diagnosis