7.4
Removing the Touch Controller PCB
•
Disconnect the mains supply to Rangehood
•
Remove inner panel (refer section 7.1)
•
Remove the 2 screws holding the
controller (figure 7)
•
Slide controller out (figure 8)
•
Remove the 2 screws hold bracket
(figure 9)
•
Remove 4 screws in the controller cover
and remove cover (figure 10)
•
Slide out PCB board and disconnect
wiring harness (figure 11)
•
Reassemble in reverse order
11
Figure 7
figure 8
figure 9
Figure 10
Figure 11
590125