BOREY TECH T Series Instructions Manual page 9

BEI JING BOREY TECH CO., LTD Website:www.en.boreytech.com
installing feeders.
1 Install steps:
1.Open the feeder to loading state
Lift feeder fixed handle,left hand press feeder handle,while the right hand hold the small
metal piece on the right side of the feeder ,and then release the feeder handle ,loosen the
small metal piece on the right hand after there is effective tilt（Figure 1）
Figure 1
2.Installing the tray
Place the trays in tray warehouse behind the feeder.Pull out about 10cm long strip to
separate the epidermis and the strip,as shown in Figure 1 into the transfer positions.Part of
the strip should be close to the gear ,the material skin needs to cross the upper slotting
（Figure 2）into the middle of the two gears after through two white guide wheels.