BOREY TECH T Series Instructions Manual page 25

BEI JING BOREY TECH CO., LTD
3.1.Edit the smallest unit component
Firstly observe PCB' structure,mainly same groups of components amount,and find
smallest unit like figure 2,then save every component in the unit.On figure 2 there are 3
light beads and 1 resistor.Please save them separately.
3.2.First-level array setting
Take Figure 1 for example,there are 32 units on jointed boards,smallest unit is the three
lights and one resistor at the lower-left corner(Figure 2),we have finished save by above
step.Now observe the array of this board(Figure 3),Xdirection has 4 same units,Y direction
has 8 sameunits.So we set 4 in X and 8 in Y in first-level array,then OK to save.
Website:www.en.boreytech.com
Figure 1
Figure 2