Advertisement
BEI JING BOREY TECH CO., LTD
Firstly select feeder stack's No.,press F1 to finish fast position up to the top of the
corresponding stack,press F2 to open the feeder cover,switching to coarse adjustment and
move XY axis to make cross mark of camera is in the center of component,then press OK to
save.Set other coordinates separately.See above picture.
2.2Setting the height of feeder
As the picture:
Press F2 to open the feeder cover,move Corresponding nozzle on the top of componen
"z&a:keep pressing up and down key" and hold↓,when touching components,the height is
suction height,then press OK to save.Two nozzles should be set separately.
Notice!!Do not press angle motor of nozzles by hands;If do that will result damage motors or
nozzles can;t return.
2.3.Set suction speed
As the picture
Website:www.en.boreytech.com
Advertisement
