Advertisement
BEI JING BOREY TECH CO., LTD
In fact basic point of first board in second array in basic point of end board in first
array;After saving basic point of end board in first array,please switch it to second
array and save it to basic point of first board in second array;The precondition is X
and Y not moved after saving first level array,it should be switch to moving table
directly.(Factory+Speed)
Basic point of end board in second array is same point which is in an X axis and
farthest unit with basic point of first board.Please see Figure 8.
Operator only move PCB moving table,then find basic point of end board by
camera,then OK to save.
（A） The operator should set the relationship between nozzle and shelf frame and relationship
in parameter settings to one-to-one correspondence in the programming,otherwise the
programming will be disordered.
（B）Pay attention to when it comes to "first-level array"during programming,the operator
only allows to move the XY axis for positioning,PCB sliding table movement is not
allowed,then when involving
move the PCB sliding table,not allowed to move XY axis.
（C）There are a lot of kinds of sketchpad software,so leading-in is not included in the scope of
Website:www.en.boreytech.com
Figure 8
Programming Tips
"second-level array"when in programming,only allowed to
Advertisement
