Advertisement
BEI JING BOREY TECH CO., LTD
2.The operation buttons introduction
1)Factory mode
2)Moving speed option key of each axis(long span,the coarse tuning and fine tuning)
3)Nozzle change
4)Shelf frame +
5)Shelf frame -
6)Page up
7)Page down
8)Shelf frame coordinate quickly positioned and saved in the basic parameter settings.
9)Open feeder cover in the basic parameter settings.
Next component in programming operation.
10)Sending one component to corresponding feeder in the basic parameter settings.
Quickly position to current component coordinate in programming operation.
11)Test and pick current shelf frame component in the basic parameter settings.
Valid change of component in programming operation.
12)Save and confirm key.
13)Cancel and confirm key.
14)Y axis moves to ↑
15)X or P axis(sliding table) moves to ←
16)Y axis moves to ↓
17)X or P axis(sliding table) moves to →
18)Selected nozzle risen.
19)Selected nozzle rotated counted clockwise.
20)Selected nozzle down.
21)Selected nozzle rotated clockwise.
Website:www.en.boreytech.com
Advertisement
