Setting The Turnaround Timeout - Ingenico i6550 User Manual

Setting the Turnaround Timeout

6.4.10
The Turnaround Timeout indicates the time a concentrator or a hub will wait between its
request for data and a device's response in a poll sequence.
Display
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Enter Password:
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Sys Parameters
Download Method
Download Port
Setup Port
Setup Port
Port1
Port2
Port X
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
LAN Address
Retry Count
Response TMO
Poll TMO
Turnaround TMO
Turnaround TMO
Old Value: 300
Enter New Value:
46
Action
To access the extended menu, restart the terminal
by pressing [1] + [CAN] + [OK]; while the terminal
is starting up, access the extended menu by
pressing the [1] and [3] keys simultaneously.
Press [ ], [ ], [ ], [Enter] to select Supervisor
Menu.
Key password [2] [6] [3] [4], then press [Enter].
Press [ ], [ ], [ ], [Enter] to select Sys
Parameters.
Press [ ], [ ], [Enter] to select Setup Port.
Select Port1 or Port2.
(By default, Port 1 = Host, Port 2 = Aux.)
Press [ ] eight times, then press [Enter] to select
Turnaround TMO.
Enter an amount of time after which the port
should cease turnaround, in units of 1/100 of a
second.
Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port