8.13 Removing the lamp assembly
For rear lamp assemblies
1.
Ensure the product is isolated from the power
supply
2.
Remove the oven lamp cover and bulb. Refer to
Section 8.12 on pg. 57.
3.
Remove the lamp body retaining screws and
the lamp holder retaining screws
4.
Disconnect the lamp assembly wires at the
connectors in the back panel area
5.
Pull the lamp assembly wires out through the oven
cavity
Note: String can be tied on the end of the light
assembly wires to aid in feeding the new wires back
through the holes in the side insulation panel.
Reassembly
1.
Feed the new wire connectors back through the
hole in the side insulation panel
2.
Refit in reverse manner
For front lamp assembly
Removal
1.
Remove the lamp cover and bulb. Refer to
Section 8.12 on pg. 57.
2.
Disconnect the lamp assembly wires from the
terminal blocks in the top panel area
3.
Remove the control panel. Refer to Section 8.4 on
pg. 51.
4.
Remove the three screws along the front of the
wiring panel and the two screws either side
that retain the wiring panel
5.
Lift the front of the wiring panel to access the
lamp assembly and wires
6.
Remove the lamp holder retaining screws
7.
Feed the wires through the hole in the wiring
panel
Reassembly
1.
Refit in reverse manner
58