Display Module Removal
1.
Release the four clips from the sides of the display module using pliers
2.
Lift up on the display module, disconnect harnesses and remove the module
Note on Reassembly:
1.
When reinstalling the display module, the keyhole openings in the display housing should clear
the mating pins on the button tree
2.
Make sure the tabs on the ends of the display are engaged in the mating slots in the clips
on the encoder brackets as shown above
3.
When the display module is properly assembled, it will be positioned hard against the back of
the glass
Keyhole opening
Clips - 4 corners
Button tree
(behind ESD film)
53