Removal Of The Power Board - Fisher & Paykel DCS WOSV230 Service Manual

8.6 Removal of the Power Board

There are 2 power boards in a double model. The master board is the upper cavity module, and the
slave board is the lower cavity module. Both these modules are connected via a harness and are
located in the top panel area.
A single model only has one power board which is the master board.
Procedure:
1. Remove the oven doors. This makes the
product lighter and easier to move, and will
stop it tipping forward when pulled out from
the joinery.
2. Remove the screws securing the product to
the joinery and slide the oven forward out of
the joinery approx. 10" (250mm)
3. Remove the 4 screws (2 front, 2 rear) retaining
the service panel
4. Lift the service panel and slightly tilt to remove
it from the control panel. Slightly raise the
rear panel to gain access to the power board.
5. To remove the power board, use a pair of long
nose pliers and squeeze the plastic standoff to
release
6. When replacing the power board, ensure you
take note of the wiring harness positions
7. Reassemble in reverse order. Once powered
on, ensure the model ID is set for the model
you are working on. Refer to pg. 35 for the
model ID references.
Service
panel
Squeeze to
release
54