Fisher & Paykel DCS WOSV230 Service Manual page 51

Glass Pane Removal
1. Remove the screws securing the top retaining
bracket (no. 1)
2. Loosen the screws on the insulation retainer
panel (no. 3)
3. Slide out the heat reflective glass pane (no. 4)
4. Remove the inner glass pane and gasket
Note: If transferring the gasket to a replacement
glass pane, ensure the gasket join is located at the
top of the door.
Note: The glass pane has a reflective coating on
one side only. Ensure that the coating is facing the
oven cavity when reassembled.
To test if a glass pane has a heat reflective
coating, use an ohmmeter to test for continuity
on the glass surface. If there is continuity, the
glass will be coated.
Reassembly
Refit in reverse manner
Ensure all glass surfaces are clean
Handle Removal
1. Clear the insulation from around and remove
the handle retaining screws in the top corners
of the outer door assembly
Reassembly
Refit in reverse manner
Glass Pane Removal
1. Remove the screws securing the heat shield
panel (no. 5)
2. Loosen the four screws securing the bottom
flow guide panel (no. 6)
3. Slide the heat reflective glass pane (no. 1) out
from the bottom flow guide panel
Reassembly
Refit in reverse manner
1
8
7
3
1
4
5
4
1
5
6
3
9
13
2
6
3
8
9
10
2
4
11
12
7
8
50