Removal Of The Cooling Fan; Removal Of The Vent Fan - Fisher & Paykel DCS WOSV230 Service Manual

8.16 Removal of the Cooling Fan

1. Ensure the product is isolated from the power
supply
2. Remove the product from the joinery. Refer to
Section 8.1 on pg. 49.
3. Remove the rear panel to gain access to the
cooling fan(s)
Single models and double upper cavity
4. Remove the wires from the cooling fan motor
5. Remove the two screws on the cooling fan and
slide it out from the locating slot
6. Remove the four small retaining screws for the
cooling fan side brackets and transfer the
brackets to the replacement cooling fan
7. Reassemble in reverse order
Double model lower cavity
8. Follow instructions 1 to 3
9. Remove the wiring to the lower cooling fan
10. Remove the two screws on the right of the
cooling fan and slide it out from the locating
slot
11. Remove the four small retaining screws for the
cooling fan side brackets, and transfer the
brackets to the replacement cooling fan
12. Reassemble in reverse order

8.17 Removal of the Vent Fan

1. Ensure the product is isolated from the power
supply
2. Remove the product from the joinery. Refer
to Section 8.1 on pg. 49.
3. Remove the rear panel to gain access to the
vent fan(s)
Single model and double upper cavity
2. Remove the vent fan retaining screws
3. Remove the longest section of vent ducting
4. Remove the vent fan wires
5. Lift the vent fan out of the vent ducting and
rotate counter-clockwise to clear surrounding
parts
6. Separate the vent fan from the vent tube
For lower cavity in double ovens
2. Remove the vent fan retaining screw
3. Remove the lower section of vent ducting
4. Remove the vent fan wires and transfer them
to the replacement fan
5. Separate the vent fan from the vent tube
Reassembly
Refit in reverse manner.
Screws
Screws
60