Fault Codes - Fisher & Paykel WASHSMART WA1068G Installation Manual/User Manual

FAULT CODES

If a continuous series of beeps sounds, all the lights turn off on the control panel and a
number appears on the display, a fault has occurred. The washer automatically enters this
mode when there is a fault. The word 'Fault' will be shown in the control panel display
followed by a number (refer to example shown here). To stop the beeps, touch any button
then perform the following steps:
1 Turn your machine off at the wall.
2 Wait for 60 seconds and turn it back on.
3 Check the machine is level, refer to 'Levelling'.
4 Remove load and retry.
5 Complete a deep and .
RINSE SPIN
6 If the fault re-occurs repeat Step 1.
If the machine still will not work call your Fisher & Paykel Dealer or Fisher & Payel trained
and supported service teachnician to arrange service.
40