I Offset Frequency; I Subaudible Tones - Icom IC-V8 Instruction Manual

5
REPEATER OPERATION

I Offset frequency

When communicating through a repeater, the transmit frequency is
shifted from the receive frequency by an amount determined by the
offset frequency.
q
Push [A•
w
Push [Y] or [Z] several times until "±" and
offset frequency appear.
e
Rotate [VOL] to select the desired offset
frequency.
• Selectable steps are the same as the pre-set tuning steps.
• The unit of the displayed offset frequency is "MHz."
r
Push [#•

I Subaudible tones

Some repeaters require subaudible tones to be accessed. Sub-
audible tones are superimposed over your normal signal and must
be set in advance.
q
Push [A•
SET MODE
w
Push [Y] or [Z] one or more times until "rt"
appears.
e
Rotate [VOL] to select the desired subaudible tone.
r
Push [#•
Available subaudible tone frequencies
67.0 79.7
69.3 82.5
71.9 85.4
74.4 88.5
77.0 91.5
22
], then push [8•
FUNC
] to fix the offset frequency and exit
ENT
], then push [8•
FUNC
.
] to enter the selected tone and exit set mode.
ENT
94.8 110.9
97.4 114.8
100.0 118.8
103.5 123.0
107.2 127.3
] to enter
SET
] to enter
SET
131.8 156.7 171.3
136.5 159.8 173.8
141.3 162.2 177.3
146.2 165.5 179.9
151.4 167.9 183.5
SET MODE
USING
.
SET MODE
SET MODE
SET MODE
USING
F
MR
(unit: Hz)
186.2 203.5
189.9 206.5
192.8 210.7
196.6 218.1
199.5 225.7
.
TX
229.1
233.6
241.8
250.3
254.1